Allen&Heath Xone K1/K2/K3

Mapping by Be, from Mixxx · Mixxx manual page

This mapping can be used with one or multiple Xone K1s/K2s/K3s. Multiple Xone K1s/K2s/K3s can be connected to each other via X-Link with one of them connected to the computer via USB. Alternatively, when using 2 K1s/K2s/K3s, they can both be connected with their own USB cable and this same mapping can be loaded for each. The layout of the mapping depends on the configured MIDI channel of the controller. Change the MIDI channel of the controller by pressing the bottom right encoder (labeled "Power On Setup/Scroll/Set") while plugging in the controller. Scroll with the encoder to select a MIDI channel. The letter in parentheses corresponds to the last lit button when selecting the channel: Channel 15 (O, default out of the box): two decks + two effect units with decks in the middle Channel 14 (N): two decks + two effect units with effect units in the middle Channel 13 (M): two decks + two effect units with decks on left Channel 12 (L): two decks + two effect units with decks on right Channel 11 (K): four decks ordered 3 1 2 4 Channel 10 (J): four decks ordered 1 2 3 4 Channel 9 (I): four effect units ordered 3 1 2 4 Channel 8 (H): four effect units ordered 1 2 3 4 If you are using K2s, they must have Latching Layers turned off, which is the default (the K1 does not have Latching Layers). If you are using the Xone K3, update it to firmware v1.0.4 r 93846 before using this mapping. Refer to the Mixxx manual for details.

This mapping doesn't describe its controls one by one, so there's no list here yet. The Mixxx manual page above shows the layout.

Generated from res/controllers/Allen and Heath Xone K2.midi.xml. If something here is wrong on your controller, tell us.